Schematic Diagram: Heating Station Calibration SOP for DPH Blister Machines

The DPH series Blister Packaging Machine utilizes a precision Heating Station to prepare PVC webs for thermoforming. As the base material is unwound, it indexes between the upper and lower heating plates, reaching the optimal glass transition temperature to become fully pliable for precise cavity formation.

Standard Operating Procedure (SOP): Heating Plate Calibration
  • 1. Lower Heating Plate Alignment: During the forming cycle, the horizontal plane of the lower heating plate [3] must perfectly match the lower forming mold at its maximum elevation. To calibrate: Inch the machine until the lower forming mold reaches its highest closed position (Top Dead Center). Adjust nuts [5, 6] to elevate the lower heating plate to the exact horizontal level of the mold (standard baseline height is 375mm). Lock nuts [5, 6] to secure the elevation.
  • 2. Upper Heating Plate Pressure Calibration: To ensure uniform heat distribution and softening, the upper heating plate [2] must apply even spring-loaded pressure across the web. With the lower mold still at its highest position and the mechanical cam [25] in the downward stroke, actuate cylinder [23] via the HMI control panel to close the plates. Adjust nuts [12, 13] to establish a precise 1.5mm tolerance gap between the nut and washer. This gap guarantees optimal spring force for uniform surface contact. Upon completion, retract the upper plate via the control panel.
Schematic diagram of DPH Series Blister Packaging Machine heating station
1. Upper Junction Box | 2. Upper Heating Plate | 3. Lower Heating Plate | 4. Lower Junction Box | 5. Adjusting Nut 1 | 6. Adjusting Nut 2 | 7. Connecting Base | 8. Guide Pillar | 9. Guide Sleeve | 10. Cylinder | 11. Support Bar | 12. Adjusting Nut 3 | 13. Adjusting Nut 4 | 14. Upper Heating Plate | 15. Lower Heating Plate | 16. Cap Nut | 17. Ball Head Nut | 18. Upper Support Plate | 19. Reinforcing Rib | 20. Lower Support Plate | 21. Guide Pillar | 23. Cylinder | 24. Cylinder Holder | 25. Cam